Bloomington Porta Pros arranges temporary power pole setups that pair with our site rental fleet, though the pole and meter installation itself is handled through a licensed electrician and the local utility. A typical construction site runs a 200 amp temporary service until permanent power lands. We coordinate scheduling so your portable toilet rental and power arrive together.
A temporary power pole, sometimes called a spider box pole or a temp pole, is a freestanding post that carries a meter socket, breaker panel and outlets so a construction crew has electricity before the building has permanent service. It gets set near the temporary fence rental line or at the site entrance, close enough for cord runs to reach saws, light tower rental units and pumps without crossing foot traffic. Most jobs spec either a 100 amp or 200 amp temporary power pole depending on the tools running at once. GFCI protection on construction circuits falls under OSHA 1926.404(b)(1)(ii), so a temp pole built for a jobsite needs that protection built into the panel, not added later. Bloomington Porta Pros does not pull the electrical permit or wire the pole. We help you sequence delivery so the pole, the construction dumpster rental, and the sanitation units land on the same morning instead of three separate trips.
Installing a temporary power pole starts with a call to the utility to confirm the drop location and a licensed electrician to build and inspect the pole itself. Placement matters as much as wiring. The pole needs stable, firm ground under it, similar to the footing standard in ADA Standards section 302.1, and enough clearance that a roll-off dumpster rental delivery truck or a restroom trailer rental can maneuver without snagging a cord or guy wire. A roll-off delivery alone needs about 60 feet of straight clearance behind the truck, so if the pole sits near the site entrance, plan the swing path before the truck shows up. Keep the pole away from the accessible route required for an ADA accessible porta potty, since ADA Standards section 403.5.1 calls for a 36 inch clear width and a cord running across it defeats that. Bloomington sites with tight lots benefit from mapping out unit and pole positions together using our porta potty placement guide before anything gets delivered.
Installation cost is not something we quote, since it runs through your electrician and the utility, not through Bloomington Porta Pros. What we can tell you is how to budget the sanitation side that usually rides alongside it. A standard portable toilet on a Bloomington jobsite runs in the range below, and pairing it with a pole delivery on the same day often saves a separate mobilization trip.
| unit | duration | typical price |
|---|---|---|
| standard toilet | day | $150 |
| standard toilet | week | $200 |
| standard toilet | month | $200 |
| delivery fee | day | $150 |
Crews running multi-week jobs usually rent by the month rather than the week once the pole and other site services are locked in; see monthly porta potty rental for how that pricing breaks down, or check porta potty rental cost for the full range across durations.
The diagram matters because inspectors and electricians use it to confirm meter height, breaker sizing, grounding rod placement and clearance before energizing the pole. Every utility and inspector wants that layout on paper first. It also helps you plan where NOT to put a storage container rental or handwashing station rental, since those need clearance from the pole's guy wires and grounding rod just as much as workers do.
Yes, in most cases, but the specific permit rule for Bloomington needs confirming directly with the city rather than assumed from another jurisdiction. Pair that call with a check on placement rules covered in our porta potty permit requirements page, since both often route through the same department.
It depends on the tools running simultaneously. Small crews with hand tools and one saw often get by on 100 amp service. Larger sites running welders, multiple saws and a light tower rental unit typically need a 200 amp temporary power pole to avoid tripping breakers under load.
Once the utility approves the drop location, a licensed electrician typically completes the physical build and inspection within a day or two, though utility scheduling can add time. Book it early alongside your construction site services so the pole isn't the item holding up mobilization.
No. We handle portable sanitation, dumpsters, fencing and storage delivery, not electrical work. We coordinate delivery timing so your pole, roll-off dumpster rental, and restroom units arrive together, but the pole itself goes through a licensed electrician and the utility.
Keep it clear of the accessible path and away from service truck routes. A tech servicing units under our how often are porta potties cleaned schedule needs a clean approach, and a pole with guy wires in that path becomes a hazard for everyone on site.
OSHA does not have a rule specific to power pole hardware, but GFCI protection on construction circuits is required under 1926.404(b)(1)(ii). For toilet counts on the same site, OSHA 1926.51(c) sets the ratio, and our OSHA portable toilet requirements page covers that separately.
Yes. Bloomington Porta Pros delivers temporary power pole across Bloomington and the surrounding metro, with same-day and next-day drop-off available on most orders.
Pricing depends on the unit and how long you need it. See our cost breakdown and request a free quote for an exact figure.
Standard rentals include scheduled service — a pump-out, a clean, a restock and fresh deodorizer. Busy or hot-weather sites can be serviced more often.
Call now or request a free quote — clean units, on-time delivery, transparent pricing.
